How To Change the IP Address of an IP Camera

How To Change the IP Address of an IP Camera

Connect to the Cameras IP Address

1. Navigate to the cameras IP Address and Login.
Notes
Note: Your computer must be configured to be on the same IP Address
scheme as the camera. Please contact your network administrator for more
information on setting your computer’s IP address.

2. Click “Setup” on the menu at the top.
3. On the left click “Networking”.
4. Ensure ‘Obtain IP Address’ is set to static.
5. Set the IP address to match your network.
Notes
Note: You may need to contact your IT department to verify which IP
addresses are available.

6. Set your Subnet Mask and Default Gateway to matrion your network.
Notes
Note: You may need to contact your IT department to verify network settings.

7. Click ‘Save’ to activate the settings.

Notes
The camera will log you off and ask you to log into the camera again.
Note: If the camera’s IP address changed to a different network. You may need
to change the IP address of your computer to match the new networking
scheme.


    • Related Articles

    • Troubleshooting Image Quality Issues on an IP Camera

      Image quality issues on an IP camera can stem from a variety of factors, including poor lighting, lens settings, network problems, or hardware faults. Whether dealing with blurry images, low resolution, or poor color balance, the following ...

    • How to Troubleshoot When IP Cameras Are Not Detected by the NVR

      If your IP cameras are not being detected by the NVR, follow the steps below. These troubleshooting methods cover most scenarios, but if issues persist, please contact technical support for further assistance. General Troubleshooting Steps for IP ...